4
INSTALLATION
Position the unit on a flat, level surface capable
of supporting the entire weight of the unit
when full. The unit contains four (4) adjustable
leveling legs. Turn the leg’s clockwise to raise and
counterclockwise to lower.
To install the handle, follow the instructions
below.
1.
Remove the gasket on the right side.
2.
Take out the screws from bag in cabinet. Put
the screws in the holes where the handle is
to be installed.
3.
Align the handle with screws, tighten the
screws using a screw driver until the handle
is both flush and secured tightly against the
door side. (DO NOT over-tighten as this
may cause damage to the door surface.).
Put the screws on top of the drawer where the
handle is to be installed. Align the handle with
screws, tighten the screws using the screwdrivers.
1. Position the unit to allow free air flow through
the front grille.
2. Wipe out inside of the unit with a damp cloth.
3. Be sure to install the Anti-Tip Bracket. Follow
instructions provided with the Anti-Tip Bracket.
LEVELING THE UNIT
INSTALLING HANDLE
LOCATION OF PARTS
ELECTRICAL CONNECTION
Improper use of the grounded plug can
result in the risk of electrical shock. If the
power cord is damaged, have it replaced by a
qualified electrician or an authorized service
center.
WARNING!
3.
The unit must be installed according to your
local codes and ordinances.
4.
ELECTROCUTION HAZARD!
• Electrical Grounding Required - This
appliance is equipped with a three
prong (grounding) polarized plug for
your protection against possible shock
hazards.
• NEVER remove the round grounding
prong from the plug.
• NEVER use a two prong grounding
adapter.
• NEVER use an extension cord to connect
power to the unit.
• Where a two-prong wall receptacle is
encountered or a longer power cord is
required, contact a qualified electrician
to have it replaced in accordance with
applicable electrical codes.
