3
REMEMBER, during the winter months, this switch should be in the “ON”
position to insure heating demand is satisfied.
The POWER switch must be set in the “MAX” position when a
2 – stage thermostat or outdoor thermostat is installed and used to control the
electric elements of the second stage.
The “CONTINUOUS FAN” switch turns the blower on to continuous “LOW”
speed. This feature will filter the air and provide for better distribution in the
building.
Manual Furnace Controls
FAULT INDICATORS
The two left hand element LEDS also serve as fault indicators.
Should the airflow be restricted by dirty air filters, these two LEDs will flash to
indicated poor air flow. Simply turn off the furnace and replace the filter with one
the same as the original equipment and restart the furnace. The fault condition
should reset.
CIRCUIT BREAKER
The circuit breaker is located at the right hand side of the front control panel
In the event that the fan motor or external device failure, the circuit breaker may
trip.
Only a licensed technician should investigate the fault condition.
Pushing in the white button will reset the breaker. If the button fails to remain
depressed, the fault condition may still exist.
Contact your service technician.
