SET UP & USE:
4
5
SET UP & USE (continued):
To use the Parent’s Unit in Portable Mode
NOTE:
Parent’s Unit should be charged 12-16 hours before first use. After
initial 12-16 hour charge, to achieve optimal battery life, charge battery
when overnight by plugging in AC adaptor and unplug all day
during use.
Step 1:
For use in portable mode, the Parent’s Unit requires one 3.6V
rechargeable battery (included). When the power LED is amber color,
the battery needs to be recharged.
Parent’s Unit Battery Installation:
Note:
This step is only needed if replacing battery.
Step 1:
Locate the Battery Compartment on the back of
the Parent’s Unit and loosen the 2 battery compartment
screws with a Phillips head screwdriver.
Step 2:
Open Battery Compartment door and
connect battery (Figure C). Ensure correct connection.
Replace door and tighten 2 screws.
Step 3:
If a battery is exhausted, remove it immediately from
the Parent’s Unit and properly disposed of exhausted battery.
To use the Baby’s Unit outside of Crib:
Step 1:
Remove Mounting Bolt Cap from Parent’s Unit.
Step 2:
Remove Mounting Bolt by lifting tab and
sliding Mounting Bolt down out of groove (Figure D).
Step 3:
Place Baby’s Unit in the nursery or on a flat
surface, such as a dresser, bureau or shelf (not in the
crib or within child’s reach).
NOTE:
There is an AC adaptor jack on the back of the
Baby’s Unit under the sliding mount bolt (Figure E).
A Baby’s Unit AC adapter (#02770) is available by
calling Summer Infant Customer Service.
WARNING:
Prevent cord entanglement. When using Baby’s Unit with an
AC adapter do not place Baby’s Unit in crib or within arm’s reach of baby.
Never use extension cords with AC adaptors. Only use the AC adapter
purchased from Summer Infant.
Testing the Unit:
You should be able to clearly hear all levels of sound coming from the
Baby’s Unit through the speaker on the Parent’s Unit. If no sound comes
from the speaker on the Parent’s unit check to make sure all cords are fully
plugged in and connected and make sure the batteries are fresh. Make
sure both units are turned on and on the same channel.
Baby’s Unit
Step 1:
Remove the Mounting Bolt Cap by turning it
counter-clockwise (Figure A).
Step 2:
Using a Phillips head screw driver remove the
4 screws to the battery door on back of unit.
Step 3:
Insert 4 “D” batteries (not included) in the
back of the Baby’s Unit and replace battery cover.
Step 4:
Position the Baby’s Unit so that the mounting
bolt passes between two vertical crib rails, with the top
piece of the Baby’s Unit resting on the horizontal
crib rail (Figure B).
Step 5:
Screw the Mounting Bolt Cap onto the back
post to secure in place (Figure B).
Step 6:
Switch Power on and switch Channel Switch to Channel A or
Channel B.
IMPORTANT:
Please be sure that the Mounting Bolt Cap is screwed on
tightly to ensure that the Baby’s Unit is mounted securely in place.
Baby’s Unit Battery Life Information:
Hours Baby Unit is on per day
Months of Use
6
13.2
12
6.6
16
5
24
3.3
Note:
Turning Baby’s Unit off when not in use is recommended to conserve
battery life.
Parent’s Unit
Step 1:
Place the Parent’s unit in the room from which you want to monitor
your baby (i.e. bedroom or living room). Plug the AC adapter into the AC
Adapter Jack on the left side of the unit and the other end into a standard
electrical outlet.
Step 2:
Turn unit on and adjust volume level by using Volume/Power Dial
on left side of Parent Unit. Set Unit to Channel A or Channel B depending
on which channel Baby’s Unit was set to.
A
B
C
D
E
connect
battery
lift tab
and
slide down
AC
adaptor
jack
