SummaSign Pro T-series Cutters
User’ s Manual
General Information
1-19
FIGURE 1-8 :
KNIFE DEPTH TEST PATTERN
The knife depth is correctly set when the test pattern is visible on the front
side of the media backing, but not on the rear side of the media backing.
In general, you should increase the knife depth and knife pressure when
using thicker types of vinyl.
NOTE
As the ideal knife pressure and depth setting depends upon the
thickness and the type of media to be cut, adjusting the pressure and
depth of the knife will require some practice. In general terms, you
should increase the pressure and depth of the knife when cutting
thicker types of vinyl . For thinner types of vinyl, you will normally have
to reduce the knife pressure and depth.
CAUTION
After setting the cutting depth and/or the knife pressure, perform a
thorough visual check of the knife blade, which can be seen
protruding from the knife holder, and test cutting results on a scrap of
vinyl media.
DO NOT OPERATE THE CUTTER if the knife blade cuts through the media
backing, as this will seriously damage the cutter's rubber cutting strip
and the knife.
Summary of Contents for T1010 Pro
Page 1: ......
