background image

Perform an arc test   

1. 

Tap Arc test icon (        ). 

2. 

After “Arc Test Ready” 

appears, tap Set icon

. An 

arc test is started. 

3.

 When the splicer shows 

“Good arc state”, prepare fiber 

again to proceed to the 

splicing process. *Fibers are 

not spliced in the arc test. 

Start splicing process / Start heating cycle 

1. 

Tap Set icon

 

 to start 

the splicing process. 

2.

 Fusion splicing is completed. 

3

. Open the wind hood. A proof 

test is automatically carried 
out. 

4.

 Remove the fiber from the

splicer. Center the protection
sleeve over the splice and
load the fiber in the heat
shrink oven. 

Sumitomo Electric Industries, Ltd. reserves the right to change the specification or design without 

notice and may therefore not coincide with the contents of this quick reference guide. E&OE 

For further detailed operating instructions and functions, please see Operation manual.   

The Operation manual can be downloaded via 

http://www.rim-plus.sei.co.jp/index.html

 

OME2024102-2/Ver.1.00 

Heater progress bar 

* Repeat fiber preparation and arc tests 

  until “Good arc state.” is displayed. 

Heating in progress 

Pre-heating

Cooling 

Standby 

Operating procedures 

Splice Program setting 

1.

 Tap the Splice Program label 

on the Settings panel. 

2. 

Select fiber category. 

3.

 Tap the Splice Program you 

would like to use. 

* Setup and change the Heater Program in the same procedures as described above. 

* ”Quick” heater program only   

*AS24G180*

 

5.

 Tap Heater icon    to start 

the heating process. 

Reviews: