Operation & Maintenance Manual
3
Cyclo® BBB5
Cyclo® BBB5
Delivery
Inspection Upon Delivery
• In order to avoid injury,
ensure that the unit is in
a stable position
before unpacking .
•
Verify that the unit received matches the order .
Using the incorrect product may cause equipment
damage or personal injury .
•
Do not
remove the nameplate from the unit .
Upon receipt of the reducer/gearmotor, verify that:
• the model number on the unit nameplate matches the
purchase order
• the unit was not damaged during shipping
• notify the shipping company immediately any damage is
found . Do not install or operate a damaged unit .
• all bolts and nuts are fully tightened.
Please consult a Sumitomo representative, distributor, or sales
office if any defects are found or if there any questions .
Nameplate Inspection
When contacting Sumitomo’s agent, distributor, or sales office
about this product, please be prepared to provide the following
information from the reducer/gearmotor nameplate:
• reducer or gearmotor model number (nomenclature)
• reduction ratio
• serial number.
Lubrication Inspection
• Oil lubricated units are shipped without oil,
unless the customer specified otherwise when
the unit was ordered.
Always fill the unit with
the correct type and quantity of lubricant prior to
operation .
• Certain models must be filled with lubricant in
two separate locations,
the Bevel Gear portion
(output) and the input portion .
Refer to the Lubrication section in this manual for detailed
lubrication information .
Nominal
Reduction
Ratio
Unit Model
Number
Unit Serial
Number
Unit Serial
Number
Unit Model
Number
Nominal
Reduction
Ratio
Metal Nameplate
Tesa® Nameplate
Non-Metallic Nameplate
(when Cyclo Input is 6120 or smaller)
Nominal
Reduction
Ratio
Unit Serial
Number
Unit Model
Number
Metal Gearmotor Nameplate
Unit Serial
Number
Unit Model
Number
Nominal
Reduction
Ratio
