Sumitomo CAK-0057-EX, Instruction Manual, Page: 21 / 27

(6) The plug cap put in the plug case may be
removed by pushing out the center guide pin on
the plug cap through the center hole of the plug
case (Fig.57) by the cap remover. Put the cap
remover on an appropriate table setting its
center pin to the center hole on the plug case,
and then hold the sides of plug case by both
hands and push it down strongly (Fig.58).
Attention:
･
Once a plug cap is removed, the plug cap and the
plug case should be replaced with new ones.(They
may be damaged with put-in and remove
procedure.)
･
Remove operations should be done with care to
prevent human body from getting hurt. Especially,
if it is done with holding the cap remover by your
hand, you may be injured by the unexpected
situations, such as the pin slipped out from the cap
remover. So this operations must be done with
putting the cap remover on an appropriate table.
･
Remove operations should be done with care not to
damage the optical fibers and coil springs.
Center hole
(Fig.57)
(Fig.58)
20