PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
2-3 Air hose
Clean the hose with a blast of compressed air before connecting the hose to air tool. This will prevent
both moisture and dust within the hose from entering the tool and causing possible rust or malfunction.
To compensate for unusually long hose (over 25 ft), the line pressure should be increased accordingly.
2-4 Inserted tools
Use only the socket or adapter which are in good condition for use. The intended socket and adapter for
this air tool could are started as "Square Drive" on the specification list.
2-5 The approved eye protector, ear-muff, mouth-muffle, and gloves shall be worn when operate this
tool.
2-6 The working place shall be ventilative.
2-7 Release the on-off device in the case of energy supply failure.
3.Operation Method
3.1 On-off device
The on-off device is on the inner or outer contour of the grip. It is a "hold-to-run" type. This tool stops
rotation within few sec, after releasing the lever. For the sake of safety, place it on a level plate or on
hanger after it completely stops.
3.2 Torque Adjuster
You can adjust the torque by rotating the knob which indicated by 1 to 6. "1" indicates the smallest
torque output and "6" indicts the largest torque output.
3.3 Rotating Direction
One shall make sure the direction of rotation before actuate this tool. The "F" indicts foreword and the "R"
indicts reverse. Forward is defined as clockwise direction seen from the operator's position.
4. Maintenance
4-1 Lubrication
Before connecting the hose, apply 4 or 5 drops of #60 spindle oil at the air inlet. Use of a thicker oil can
lead to reduced performance or malfunction. If a thicker oil is used by accident, wash it away
immediately. Also, every 3 or 4 hours of operation, oiling is necessary.
4-2 Storage
Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used, the residual
moisture inside the tool can cause rust. Before storing and after operation, oil the tool at the air inlet with
spindle oil and run it for short time.
4-3 Disposal
If the tool is too seriously damaged to be used any more, drop it in a resource recycling can. Never drop
it into fire.
4-4 Ordering service Parts
For further operational and handling information or of replacement of parts and components, contact the
sale agent from whom you purchased the tool or the service division of our company.
* In ordering parts and components, give each part number, name and quantity.
4 / 6
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG
