PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
The approved eye protector, ear-muff, mouth-muffle, and gloves shall be worn when operate this tool.
The working place shall be ventilative.
Release the on-off device in the case of energy supply failure.
Operation, Adjusting and Replacing Method
On-off device
To operate this tool, just push the lever (straight type) or trigger (Gun grip type) down. The tool
continuously rotating as one push the lever trigger down and it might last running for few second.
For the sake of safety, put it on a hanger or on soft flat pad when not in use.
Change the drill bit
Disconnect the tool before attempting to put a drill bit on this tool. Use attached chuck key to untighten
the collet, then insert an appropriate drill bit according to which kind of material that you will drill hole on as
deep as it can reach. Then tighten the collet again with the chuck key.
Rotating direction
If your tool is reversible, you can change the rotating direction by switch the direction lever near the
trigger to your desired direction. Forward which is marked with an "F", means clockwise direction and reverse,
which is marked "R", indicates the counterclockwise direction. Before start operating this tool, please make
sure the rotating direction.
Use a center punch to locate the center on where you wish to locate the new hole then apply this tool. It
will not only be more precise but also prevent from the risk caused by the slip of a rotating drill bit.
If the drill bit penetrate the workpiece, keep the tool runing makes it more easy to remove this tool from
workpiece.
Maintenance
Lubrication
Before connecting the hose, apply 4 or 5 drops of #60 spindle oil at the air inlet. Use of a thicker oil can
lead to reduced performance or malfunction. If a thicker oil is used by accident, wash it away immediately.
Also, every 3 or 4 hours of operation, oiling is necessary.
Storage
Avoid storing the tool in a location subject to high humidity. If the tool is left as it is used, the residual
moisture inside the tool can cause rust. Before storing and after operation, oil the tool at the air inlet with
spindle oil and run it for short time.
Disposal
If the tool is too seriously damaged to be used any more, drop it in a resource recycling can. Never drop
it into fire.
Ordering service Parts
For further operational and handling information or of replacement of parts and components, contact the
sale agent from whom you purchased the tool or the service division of our company.
* In ordering parts and components, give each part number, name and quantity.
4 / 6
PNEUMATIG.EU - GDYNIA UL.WIELKOPOLSKA 158 -
)
58 622 49 22
PNEUMATIG
