Section 2
11
FILTERS AND MOISTURE SEPARATORS
COMPRESSED AIR FILTERS
2.1
SAFETY INFORMATION
2.2
DESCRIPTION
Sullair Compressed Air Filters have been designed
to remove airborne contamination in a compressed
air stream, delivering energy efficient operation and
reliable performance. The air filters have multiple
ranges of efficiencies for a full range of industrial
applications. See
Table 2-1:Element Specifications
2.2.1 FX F
ILTERS
1/4” to 3” NPT up to 1600 cfm
These filters are equipped with differential pressure
gauge as standard.
PED (Pressure Equipment Directive)
A protected auto float drain (2 mm orifice) is standard
for reliable removal of liquid contaminant (minimum
pressure required for auto float drain is 30 psig).
Zero-porosity aluminum and durable epoxy powder-
coat finish, along with a corrosion-resistant internal
coating gives long service life. Filter combinations
are to meet specific application requirements. Filters
comply with PED and perform as per related ISO
8573 standards. These filters are equipped with
differential pressure gauges for easy maintenance
and energy efficiency. Sullair Condensate
Separators are always recommended with this
system.FW Filters
3” to 14” FLG up to 17,700 cfm
The filter housing is made of steel and externally
painted with epoxy powder paint. These filters are
equipped with differential pressure gauge as
standard.
A protected auto float drain (2 mm orifice) is standard
for reliable removal of liquid contaminants. Zero-
porosity aluminum and durable epoxy powder-coat
finish, along with a corrosion-resistant internal
coating gives long service life. Filter combinations
are to meet specific application requirements. Filters
comply with PED and perform as per related ISO
8573 standards. These filters may be equipped with
differential pressure gauges for easy maintenance
and energy efficiency. Sullair Condensate
Separators are always recommended with this
system.
2.2.2 FH F
ILTERS
1/4” to 2-1/2” NPT up to 1750 cfm (725 psi)
(See Connect sizes starting on page 21).
Manual drain is supplied as standard. The product is
made of aluminum and both inside and outside are
anodised against corrosion. No gauge is applied on
these filters. (There is no moisture separator for high
pressure.)
A protected auto float drain (2 mm orifice) is standard
for reliable removal of liquid contaminants. Zero-
porosity aluminum and durable epoxy powder-coat
finish, along with a corrosion-resistant internal
coating gives long service life. Filter combinations
are to meet specific application requirements. Filters
comply with PED and perform as per related ISO
8573 standards. These filters may be equipped with
differential pressure gauges for easy maintenance
and energy efficiency. Sullair Condensate
Separators are always recommended with this
system.
WARNING
Disconnect or depressurize compressed air
line prior to any installation or maintenance
activity. Eye protection goggles or safety
glasses are always recommended during
installation and maintenance.
WARNING
Air is not for breathing purposes. Activated
carbon filters are intended for odor removal
and are not intended for removal of CO
(Carbon Monoxide) or CO2 (Carbon
Dioxide).
Summary of Contents for FH Series
