6
Operation Instructions
1. Make sure the plug is firmly plugged into the wall socket.
2. Make sure the device water tank is placed in its correct position. (After
powering on the device for the first time, if the full tank light lights up, just
pull out the water tank then push it back to the proper position).
3. Turn the control knob to the suitable humidity setting (usually at
normal position). If the humidity level is over 60
o
C, then the device
will start removing moisture. If the humidity indoors is high, then
turn the control knob to ‘continuous’.
4. When the humidity in the room reaches below 60
o
C then the device will stop operating.
5. When the humidity in the room is over 60
o
C then the device will start removing moisture again.
6. The circulation between points 3., 4. and 5. is controlled by the set humidity.
WHEN FULL TANK LIGHT IS ON
When the water tank is full, the indication light will light up, the device will stop operating. Remove
the water in the tank, then place the water tank back in it’s proper position, the device will start
operating again.
DEFROST
When operating in low temperatures (less than 12
o
C) the surface of the evaporator will accumulate
frost and effect the efficiency of the dehumidifier. When this happens the device will go into periodic
defrost mode automatically. This is quite normal. Defrost light will come on. The device will operate
in temperatures down to 5
o
C in the area it is being used. Defrost times may vary. If the dehumidifier
freezes up turn the device off and let ice melt then turn the device back on. If the device freezes up
again it may be that the temperature is lower than 5
o
C, if it is, then you should not run the device until
the temperature rises. If the device continues to freeze up it may need looking at, return it to the place
of purchase to be sent back for service.
START OPERATION
Remove the water in the water tank
with two hands