Electronic housing display
ALARM
Excessive increase or decrease in parameters (+/- 15%
from the selected parameters).
CHECK LEVELS IN ACID/BASE CONTAINERS
CHECK PROBE CALIBRATION
WORN ELECTRODES or low conductivity
The production level shown presently on screen
corresponds to less than 50% of the preselected level.
Electrodes may be worn or water conductivity low.
Insufficient FLOW or cell disconnected
Production halted due to lack of flow, or gas in the
titanium cell detector.
ONLY SYSTEMS WITH FREE CHLORINE CONTROL
(ppm's)
INSUFFICIENT FLOW in the CHLORINE detector.
The rotary sensor detects insufficient flow. CHECK the
rotameter pendel – and solve the system's hydraulic
problem (If there is a preceding filter this must be
cleaned).
Conductivity/Cell life
Low conductivity (See section 3)
Titanium cell incrusted
(See cleaning process in section 5)
Cell surface corroded (See section 7)
ONLY SYSTEMS WITH REDOX OR FREE CHLORINE
The system has automatically stopped as Redox levels
are above the chosen values (See section 5)
Time delay
Period of non-production while system changes polarity
(0-120 sec.)
IONIZATION INTERVAL PROGRAMMER
The system is programmed to ionize for a
predetermined period each time it is started up:
Pr-- : Will run continually.
Pr30: Will run for 30 min. following start up.
Pr60: Will run for 60min. following start up.
Pr90: Will run for 90min. following start up.
Status led's
Electrolysis production
ENTER button
Right button
Left button
START UP
4
INITIAL ADJUSTMENTS
3
Water adjustments
1.Adjust the alkalinity between 90 and 110 ppm.
2.Adjust the PH between 7,2 and 7,4
3.Adjust the chlorine between 1 and 1,5 ppm.
SHOULD the water be supplied from a well: shock
chlorinate with Tricloroisocyanuric acid (2Kg./50m3
of water)
Adding Salt to the Water
Start up
ADD 5 TO 6 GRAMM SALT (WITHOUT YOD) FOR EACH LITRE OF WATER
IN YOUR SWIMMING POOL (5 to 6 kg NaCl per m3 Water). Open the bottom
valve of your swimming pool and add the Salt directly to your swimming pool
water. Let the circulation pump run during the first 24 hours your BIONET
SYSTEM IS WORKING in order to dissolve the Salt completely. Your
BIONET System will operate without any problems with salt concentrations
from 2,5g to 50g Salt per litre.
IN POOLS WHICH RECEIVE LARGE AMOUNTS OF STRONG SUNLIGHT
40gr/m3 OF STABILYSER (Isocyanuric acid) MUST BE ADDED
Up button
Down button
Ionization
pH Probe
Conductivity probe/
water temperature
Free Chlorine/Redox
