PART NUMBER
H621SFG500
ISSUE
S01
DATE
06/07/07
SUBARU OF AMERICA
PAGE
3/5
8
9
Tilt console back. Disconnect wire harness and
remove console from vehicle.
7
Using a 1
4
mm (
9
/
16
inch) drill bit,
drill a hole in console bin, about
19 mm (¾ inch) from edge.
¾”
Feed dock cable (C) through hole and place
console bin back in vehicle in upright position as
shown in slide 7.
C
10
Pry gently around edges to remove
trim panel. Note: Gear selector must
be in “N” with parking brake set,
ignition off and vehicle on level
ground. For manual transmission
vehicles, shift knob must be removed
by
unscrewing
in
a
counter
clockwise direction.
11
Route dock cable towards front of vehicle as shown. Dock cable should be routed behind HVAC
controls and up to the radio opening.