SUBARU OF AMERICA
PAGE
DATE
ISSUE
DESCRIPTION
01-08-2018
00
6/7
Verify position of part. Holding part in place,
expose tape adhesive on top flange by pulling
tape tab from end position to end of part.
NOTE:
Make sure lower two outer holes are
aligned before pulling tape leader.
Pull tape tabs on two lower flanges.
Lift up on top inner edge of bumper fascia
to ensure tape adheres to bumper. Press
into place, applying 30 psi of pressure for a
minimum of 10 seconds. Repeat application
of pressure to all remaining tape locations to
ensure adhesion. Allow 24 hours for maxi
-
mum bond.
Re-install the outer (2) rivets removed in Step 3.
8
9
10
11
