Subaru 2012 Legacy, User Manual

Page: 140 / 474

Black plate (141,1)
北 米
Model "A2480BE-A" EDITED: 2011/ 7/ 26
while the vehicle is subsequently being
driven.
.
The warning light illuminates during
driving, but turns off immediately and
remains off.
!
Vehicle Dynamics Control opera-
tion indicator light
The indicator light flashes during activa-
tion of the skid suppression function and
during activation of the traction control
function.
NOTE
.
The light may remain illuminated for
a short period of time after the engine
has been started, especially in cold
weather. This does not indicate the
existence of a problem. The light
should turn off as soon as the engine
has warmed up.
.
The indicator light illuminates when
the engine has developed a problem
and the CHECK ENGINE warning light/
malfunction indicator light is on.
The Vehicle Dynamics Control system is
probably malfunctioning under the follow-
ing condition. Have your vehicle checked
at a SUBARU dealer as soon as possible.
.
The light does not turn off even after
the lapse of several minutes (the engine
has warmed up) after the engine has
started.
&
Vehicle Dynamics
Control OFF indicator
light
The light illuminates when the Vehicle
Dynamics Control OFF switch is pressed
to deactivate the Vehicle Dynamics Con-
trol system.
The Vehicle Dynamics Control system is
probably malfunctioning under any of the
following conditions. Have your vehicle
checked at a SUBARU dealer immedi-
ately.
.
The light does not illuminate when the
ignition switch is turned to the
“
ON
”
position.
.
The light does not turn off even after a
period of approximately 2 seconds after
the ignition switch has been turned to the
“
ON
”
position.
&
Security indicator light
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
!
Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to
“
Alarm system
” F
2-
15.
!
Immobilizer system
This light blinks approximately 60 seconds
after the ignition switch is turned from
“
ON
”
position to the
“
Acc
”
or
“
LOCK
”
position or immediately after the key is
pulled out. Refer to
“
Immobilizer
” F
2-3.
If the indicator light does not flash, it may
indicate that immobilizer system may be
malfunctioning. Contact your nearest
SUBARU dealer immediately.
In the event that an unauthorized key (for
example, an unauthorized duplicate) is
used, the security indicator light illumi-
nates.
NOTE
Even if the security indicator light
flashes irregularly or its fuse blows
(the light does not flash if its fuse is
blown), the immobilizer system will
function normally.
Instruments and controls
3-21
–
CONTINUED
–
3