Subaru 2011 Outback, Owner'S Manual

Page: 30 / 495

Black plate (33,1)
一 般
Model "A2470GE-B" EDITED: 2010/ 9/ 24
WARNING
To prevent the passenger from slid-
ing under the seatbelt in the event of
a collision, always put the seatback
in the upright position while the
vehicle is in motion. Also, do not
place objects such as cushions
between the passenger and the
seatback. If you do so, the risk of
sliding under the lap belt and of the
lap belt sliding up over the abdomen
will increase, and both can result in
serious internal injury or death.
!
Memory function (driver
’
s seat
—
if
equipped)
WARNING
.
Never adjust the seat while driv-
ing to avoid the possibility of
loss of vehicle control and of
personal injury.
.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers or luggage are
clear of the adjusting mechan-
ism.
.
Never retrieve the seat position
while driving to avoid the possi-
bility of loss of vehicle control
and of personal injury.
.
Perform the seat position retrie-
val before driving. Be sure to
confirm that the select lever is
in the
“
P
”
position (AT and CVT
models), and the parking brake is
applied, when adjusting the seat
position. Do not drive until the
retrieval of the seat position is
complete.
.
When retrieving a registered seat
position, make sure the hands,
feet and possessions of rear seat
passengers are clear of the seat
adjusting mechanism.
.
When any unusual conditions or
malfunctions occur during the
retrieval of the seat position, stop
the retrieval of the seat position
by performing any of the follow-
ing procedures.
–
Operate any of the power seat
switches
–
Press the
“
SET
”
button
–
Press button
“
1
”
or
“
2
”
Some of your desired seat positions can
be registered. Register the seat position
with button
“
1
”
or
“
2
”
or each of the access
keys and retrieve the seat position.
The following seat positions can be
registered.
.
Forward/backward position of the seat
.
Angle of seatback
.
Angle of seat cushion
.
Height of seat
!
Registration of seat position with
button
“
1
”
or
“
2
”
1. Adjust the seat position under the
following conditions.
.
The parking brake is applied.
.
The ignition switch is in the
“
LOCK
”
/
“
OFF
”
position.
Seat, seatbelt and SRS airbags
1-5
–
CONTINUED
–
1