Sub-Zero Wolf BBQ242BI, Service Manual, Page: 35 / 45

Page 35
OUTDOOR B BBQ G GRILLS
Component Removal
CART COMPONENTS:
Components include; BBQ Chassis, Door Handles,
Door Assembly, Doorstops, Top Catch Holder, Magnetic
Catch, Bottom Panel, Rear Panel, Side Panel, Top Trim,
Swivel Caster w/Brake, Caster Locking Bracket, Non-
Swivel Caster, 48" Cart Shelf, 48" Cart Partition and
Cart Frame Assembly
BBQ Chassis
To remove the entire BBQ chassis from the cart you will
need to turn off and disconnect the gas supply. Then
remove the control panel, rear panel and extract the
mounting bolts from the cart frame to the BBQ chassis.
Now lift the BBQ chassis from the cart assembly.
See Fig. 4-46
Door Handles
To remove the stainless steel cart door handles you will
need to open the door and extract the two screws from
the inside of the door that mount the handle to the door.
See Fig. 4-47
Door Assembly
To remove the stainless steel door assembly you will
need to open the door and extract the two screws that
mount the door hinge to the inside of the cart frame.
NOTE: If replacing the door, the door handles will have
to be removed and reinstalled on the new door.
NOTE: The door hinges are not replaceable. They are
welded to the door assembly and to replace them you
will replace the entire door assembly.
See Fig. 4-48
Doorstops with Screw and Spacer
The doorstops are located inside of the cart, behind the
doors, at the bottom front. They are to keep the door
from closing too far into the cart. The doorstop is sim-
ply a screw inserted into a spacer, then screwed as one
piece to the bottom panel. To remove the doorstop you
will need to open the door, extract the screw and then
remove the screw from the spacer.
See Fig. 4-49
Fig. 4-49
Fig. 4-48
Fig. 4-47
Fig. 4-46