Sub-Zero PRO 48, Installation Manual, Page: 3 / 32

subzero.com
|
3
Electrical
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
The electrical supply should be located within the shaded
area shown in the illustration below. A separate circuit, ser-
vicing only this appliance is required. A ground fault circuit
interrupter (GFCI) is not recommended and may cause inter-
ruption of operation.
ELECTRICAL REQUIREMENTS
Electrical Supply 220-240 V AC, 50/60 Hz
Service 10 amp
Receptacle grounding-type (earthed)
SITE PREPARATION
CAUTION
The outlet must be checked by a qualified electrician to
be sure that it is wired with the correct polarity. Verify
that the outlet is properly grounded (earthed).
WARNING
Do not use an extension cord, two-prong adapter or
remove the power cord ground prong.
Plumbing
Installation must comply with all applicable plumbing codes.
The water supply line should be located within the shaded
area shown in the illustration below. The water supply line
should be connected to the house supply with an easily
accessible shut-off valve. Do not use self-piercing valves.
The water supply line must not interfere with installation of
the anti-tip bracket.
This appliance should be connected to a potable water
supply.
PLUMBING REQUIREMENTS
Water Supply 1 /
4
" OD copper, braided
stainless steel or PEX tubing
Pressure 2.4–8.3 bar
Excess Line for Connection .9 m
1918 mm
FROM FLOOR
178
mm
E
152
mm
RIGHT SIDE
OF OPENING
Electrical supply location.
76 mm
152
mm
132
mm
RIGHT SIDE
OF OPENING
AREA EXTENDS
13 mm
FORWARD ON FLOOR
Water supply location.
Preparation
Uncrate the unit and inspect for damage. Remove the wood
base and discard shipping bolts and brackets. Remove and
recycle packing materials. Do not discard the kickplate, anti-
tip bracket and hardware.
Completely retract the front leveling legs to allow the unit to
be moved into position. The front and rear leveling legs can
be adjusted from the front once the unit is in position.
Remove the drain pan from the base of the unit to avoid
damage, and allow for proper appliance dolly placement.
The grille assembly should be removed prior to moving the
unit. To remove, pull out on the bottom edge of the grille and
rotate upward. Cut cable ties that attach the network cable
to the grille, then disconnect the network cable. Remove
three grille bolts from the grille, then pull grille forward to
remove. Refer to the illustration below.
NETWORK
CABLE
GRILLE
BOLT
CABLE TIE
Grille removal.
Electrical
Shock
Hazard
Plug power cord directly into a properly
grounded (earthed) outlet.
Do not defeat the grounding (earthing)
nature of the plug.
Do not use adapter or extension cord.
Failure to follow these instructions could
cause serious injury or death.
See installation instructions