Sub-Zero IC-24R-RH, Use & Care Manual

Page: 11 / 56

subzero.com
|
11
WATER FILTER REPLACEMENT
1
To access the water filter, pull out on the bottom edge
of the access door and rotate upward. Refer to the illus-
tration below.
2
To remove the old filter, rotate counterclockwise one-
quarter turn, then pull out. It is normal for a small amount
of water to drip when the filter is removed. It should be
wiped up with a paper towel or cloth.
3
Remove the new filter from packaging and remove
plastic cap.
4
Insert the new filter into the manifold and turn clockwise.
5
Once the new filter has been installed, follow instructions
on the control panel. The filter life cycle will reset for
approximately one year.
Water Filtration System
The water filtration system of Sub-Zero integrated models
supplies filtered water to the ice maker and water dispenser
(dispenser models) to produce great-tasting water and ice.
IMPORTANT NOTE: When using the water filtration system
for the first time and after filter replacement, it is neces-
sary to clear any air from the system and allow the filter to
assist in cleaning the water lines. For non-dispenser models,
discard the first two full containers of ice. For dispenser
models, dispense several glasses of water for a period of
two minutes.
If the water filtration system will not be utilized, it can be
placed in water filter bypass mode by removing the filter.
The filter is rated for 750 gallons
(2839 L)
or one year,
whichever comes first. ‘Change Water Filter’ will appear on
the control panel when the cartridge needs to be replaced.
Touch ‘Snooze’ to delay reminder for 24 hours or until filter
can be replaced.
Replacement Sub-Zero water filters can be ordered online
at subzerowolfstore.com. For questions, contact Sub-Zero
customer care at 800-222-7820.
OPERATION
WATER FILTER
ACCESS DOOR
Water filter removal.