16
www.pridemobility.com
Pride Stylus 450
To change the SFR foot plate length:
1.
Remove the screw from the SFR.
2.
Adjust the foot plate to the desired length.
3.
Reinstall the screw into the SFR.
4.
Repeat for the other side.
SEATBACK HEIGHT
You can adjust the seatback to one of
three different heights. The adjustment
range is 7.5 cm (3 in.) in 2.5 cm (1 in.)
increments. See figure 16.
To adjust the seatback height:
1.
Remove the bolts to unfasten the seat
canes from each side of the frame.
2.
Slide the canes up or down into one of
the three holes for the desired height.
3.
Use the bolts to refasten the seat canes
into the frame.
SEAT ANGLE (DUMP)
The position of the caster wheels affects
the angle of the seat (dump). There are four
holes in the caster fork. By changing the lo-
cation of the caster wheel on the fork, you
change the seat angle. See figure 17.
NOTE: You can also adjust the seat angle by raising or lowering the drive
wheel. See “Drive Wheel Position.”
To change the seat angle:
1.
Remove the hardware that fastens the caster wheel to the caster fork.
2.
Reposition the caster wheel on the caster fork.
3.
Reinstall the hardware that fastens the caster wheel to the caster fork.
4.
Repeat the procedure for the other side.
WARNING! Changing the seat angle may adversely affect stability and cause
the wheelchair to tip over. Failure to heed this warning can result in personal
injury and/or damage to your wheelchair.
Figure 16. Seatback Height
Adjustment
SEAT
CANES
FRAME
BOLTS
Figure 17. Caster Wheel Position
CASTER FORK
CASTER
WHEEL
Summary of Contents for 450
Page 22: ...22 www pridemobility com Pride Stylus 450 NOTES ...
Page 23: ......
