Part Number# 971830
Rev B (05/16)
Stylmark, Incorporated
♦
6536 Main Street NE, PO Box 32008
♦
Minneapolis, MN 55432
1-800-328-2495
♦
www.stylmark.com
Stylmark Installation Instructions: Optima LED® DS5 Perimeter Lit
Step-by-Step Instructions - Frame Assembly - Corners:
1.
Corners are secured together with corner brackets. A corner
bracket is pre-installed in one of the two corner segments of
each corner. See Figure 2.
2.
Use a Philips head screwdriver to remove the cover piece
from a corner segment without the corner bracket and retain
the screws. A receiving Y bracket with a socket head cap
screw and protective cap will be exposed. See Figure 4.
3.
Remove the protective cap and socket head cap screw from
the Y bracket. Discard the cap.
4.
Slide the corner bracket into receiving frame segment under
the Y bracket.
5.
Align the hole in the Y bracket with the hole in the corner
bracket. Insert the socket head cap screw through the Y
bracket into the corner bracket and tighten with a 3/16” hex
key wrench until the corner segments are firmly secured
together. See Figure 5.
6.
If the outside corner of the display frame is not aligned
properly, more adjustments will be necessary.
a.
Remove the cover from the adjoining segment with a
Phillips head screwdriver and retain the screws. This
will expose the other side of the corner bracket with a
second Y bracket connected to it with a socket head
cap screw.
Caution: There may be wiring that extends between
a cover with lights and the frame segment it was
attached to. Use caution when removing the cover.
b.
Adjust the socket head cap screws on both sides of
the corner bracket using a 3/16” hex key wrench,
until the outside corner of the frame is aligned as
desired.
c.
Re-secure the cover section of the adjoining segment
to the frame segment with the retained screws using
a Phillips head screwdriver. Make sure not to crimp
any wires under the edge of the cover.
7.
If there are electrical connectors present, connect them now.
For example, insert a male low voltage connector into a
female low voltage connector. See Figure 6.
8.
Tuck all wires and connectors under the covers and re-secure
the cover piece to the corner segment with the retained
screws using a Philips head screwdriver. Make sure not to
crimp any wires under the edge of the cover.
9.
Repeat these steps for the 3 other corners of the frame. If
there are no frame segments with intermediate (flat) ends,
the frame assembly will be complete. See Figure 7.
Figure 7
Figure 5
Figure 6
Low Voltage Connector
Line Voltage Connector
