Oct 8, 2015
○
E
ASSEMBLY INSTRUCTIONS
Caution: Using the wrench (F) to tighten parts may cause damage to painted surfaces. If possible, protect
parts before wrench tightening.
1.
Connect the T-Bar (A) with one of the two Blades (B or C) by inserting one of the threaded ends of the T-bar through the
middle hole of the Blade. (Step 1)
Be sure blade is facing the correct direction. Note label on outer side of blade.
2.
Fasten the Blade to the T-Bar by applying one Nut (D), Washer (E) and Cap Nut (F). Hand-tighten Nut and Cap Nut, then
tighten with Wrench (L). Repeat for other blade. (Step 2)
The two blades should face opposite directions.
3. Thread the Stake Bar (I) through the ring on the Two-Prong Stake (H). Align the stake on the Stake Bar with the notch on
the ring, creating a four-prong stake. (Step 3)
4. Connect the Top Bar (G) with
the assembled Stake Bar created in Step 3.
Use the Locking Screw (K) to fasten the
connection.
Use the “L” Wrench (J) to tighten
the connection. (Step 4)
5. Connect the Bar Assembly in Step 4 with the Blade Assembly in Step 2 by inserting the top of the Top Bar (G) into the end
of the T-Bar (A). (Step 5)
6. Set up your wind catcher in your garden by pushing the assembled unit into the ground.
Step 1
1
Step 2
Step 3
Step 5