www.stuv.de
02
ASSEMBLY INSTRUCTIONS
3.31.270X.X
01
Insert the outside guide (Pos.6) into the hole provided for the door and mount it with 4x countersunk head screws M5 to the front of
the door. When doing so, pay attention to the „OBEN“ mark.
02
Insert the inside guide (Pos.5) into the hole of the door and also mount it with 6x countersunk screws M5 to the inside of the door.
When doing so, pay attention to the „OBEN“ mark.
03
Insert the outside handle (Pos.1) vertically into the outside guide (Pos.6).
04
Insert the intermediate ring (Pos.4) over the inside guide (Pos.5) so that the bore in the intermediate ring (Pos.4) is inserted into the
pins of the inside guide (Pos.5).
05
Place the shim disc (Pos.3) on the bearing sleeve (Pos.7) and make sure that the recess of the shim disc (Pos.3) is pointing down-
wards.
06
Insert the inside handle (Pos.2) vertically into the bearing sleeve (Pos.7) and screw it to the outside handle (Pos.1) using the 3x
countersunk screws M6x40 (Pos.8).
07
When screwing the three countersunk screws M6x40 (Pos.8), make sure that all three countersunk screws are tightened evenly.
08
The handle must still be rotatable!
09
Insert the cap (Pos.9) into the inside handle (Pos.2). Make sure that the nose of the cap (Pos.9) is in the corresponding lock and that
the „EXIT“ label is horizontal.
10
Fit the cap (Pos.9) with the flat head screw M4 (Pos.10).
ASSEMBLY
SAFETY NOTICE
For safety reasons a second person must be on the outside of the door when testing the emergency
escape function with the door installed
PROFILE CYLINDER REPLACEMENT
When changing the profile half cylinder, make sure that the locking lug is in 90° position (3 o‘clock)
