2
2. Safety Instructions
CAUTION:
To reduce risk of electrical shock, do not remove the cover.
There are no serviceable parts inside the device. Maintenance and
service operations are only to be carried out by authorized dealers.
WARNING:
To reduce the risk of fire or electrical shock, do not expose this
appliance to rain or moisture.
This symbol indicates that dangerous voltage constituting risk of electric shock is present within this unit.
This symbol indicates that there are important operating and maintenance instructions in the literature
accompanying this unit.
If the device has been exposed to extreme temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation might damage your device. Leave the device switched off until it has reached room temperature.
The voltage and frequency must be the same as stated on the device. Wrong voltages or power outlets can lead to damage
of the device & fatal electrical shock.
Always plug in the power plug last. Make sure that the plug is connected properly to the outlet.
All operation & user instruction should be followed.
The product should be kept away from water & moisture.
Make sure the product is always well ventilated.
Keep it away from extreme heat or cold.
Make sure the power cord should be routed so that they do not get pinched & get subject to wear or tear.
Always use a dry cloth to clean the product.
DO NOT drop the product, as it may cause the product to mal-function.
Factory Repair Service maybe required in the following circumstances:
• The Power supply cord or the plug has been damaged.
• If the product has been exposed to liquid spillage, rain or heavy moisture.
• If the product exhibits a change in performance & doesn't not operate properly.
• If the product is damaged due to it being dropped.
3. Operation
Front Panel Introduction
NOTE:
Channel 1 and 2 are identical.
1. Power Switch:
This knob is used to switch the equalizer On/Off.
2. Boost / Cut Fader:
This fader is used to boost or cut a dedicated
frequency.
a. Moving the fader upward will boost frequency up to +6dB or +15dB.
b. Moving the fader downward will cut frequency up to -6dB or -15dB.
1
2
0
CLIP
6dB
EQ IN
30Hz
LOW
CUT
㊣
15dB
OUT
OFF
㊣
+12
B
d
8
-20dB
LEVEL
3
8
9
10
4
5 6
7
Summary of Contents for SEQ 152
Page 4: ......
