Studiomaster Sat 5 Instruction Manual Download Page 4

Page: 4 / 8

Pin2 + Tip = High

Pin 3 + Ring = Low

Pin 1 + Sleeve = Ground

4. Volume Control:

This knob is used to control the output level of each speaker. The input sensitivity

can be adjusted (counterclockwise reduces sensitivity) with this rear panel mounted system gain control.
Adjustment range is from -30dB to + 6dB (

Sat 5

) & -80dB to + 6dB (

t 10S

), which should suffice for

most conditions.

5. HF Adjustment:

This knob is used to control the high frequency adjustment of this speaker. Room

acoustics may dictate which type of adjustment you need to make to retain a flat frequency response
from the monitor. (Only Available In

t 5

)

6. Crossover:

This knob adjusts the crossover frequency for the built-in 24dB/octave variable

crossover. The crossover frequency can be adjusted from 50Hz to 150Hz. Frequencies below the
crossover frequency are sent to the sub-woofer.

7. Auto Power:

If set to the AUTO position the subwoofer will go into STANDBY mode (mute) if Idle

for more than 45 minutes it resumes working immediately after an input signal is received. If set to the
ON position it will be on constantly, & the OFF position allows you to use the subwoofers power switch
manually.

8. Phase Switch:

This switch reverses the polarity of the signal going to the subwoofer amplifier by

180°. It has no effect on the signal at the Left & Right out or the Master out. There is no right or wrong
setting for this switch. Listen to the overall blend of the subwoofer with the rest of the system, and select
the switch position that gives you the best sound.

9. Peak LED:

The Peak LED will illuminate if the input channels are being overloaded or distorted.

XLR CONNECTOR (MALE OR FEMALE)

1/4 INCH STEREO PHONO PLUG
(TRS aka Tip, Ring, Sleeve)

Normal “Pin-2 Hot” Diagram

For “Pin-2 Hot” Reverse Pins 2 and 3

Pin 1

Pin 2

Pin 3

Sleeve (Shield)

Tip

Ring (or sleeve)