7c
again, rotate partially assembled drawer box as shown. insert connectors of drawer box
back (DB2) into slots on drawer box sides (DB3 + DB4). push down at the connections
to lock into place. use hammer and hammer cap (F) if needed.
7b
rotate the partially assembled drawer box as shown. slide drawer box bottom (DB5) into
place using grooves on the drawer box side panels (DB3 + DB4) as guides. be sure glide
hardware on bottom panel (DB5) is positioned outside the drawer interior and toward
the drawer face (DB1) as shown.
duc insider tip!
when the drawer bottom panel is properly
installed, it should be recessed about a
1/4” from the back of the drawer sides.
still confused? scan this code to watch the assembly video!
