11
Step Eleven
Bring side modules to the closer distance
to be able to install video monitor shelf,
cable management part and front armrest.
Install one by one boards starting with the
front armrest (10), followed by video monitor
shelf (6) and end with Cable management
part (5). At this point boards are standing on
dowels only, so be very careful with the movements
to prevent any of the boards on the floor. Push modules
close enough so the boards will sitting tight to the legs.
Fix all boards with metal brackets (9) and M6
Screws (12).
6
5
10
12
Step Twelve
Place main desk board on previously installed
levelling brackets by inserting it from the back side.
Level main desk surface on your need. Fasten
the screws on levelling bracket to desk surface and
Fix all of screws once satisfied with the height.
For perfect levelling use a water levelling tool if you
have it.
10
Step Ten
Decide on which height you want to have your top
monitor shelf and fix the metal bracket (9) on the
supporting position (1) using M6 Screws. Add another
levelling brackets (16) to already installed brackets (16) as
shown on the diagram left (2). Make sure all levelling
brackets are set on the same height.
Levelling system allows you to set main desk surface up to
9 cm in depth. Take into account that the Desk surface is
25 mm thick. Fix bracket (9) on the position where your
armrest will sit (3) using M6 screws. Brackets will help you
holding panels in the next step.
2
1
3
