STA 01
‐
360 series 8
Assembly Steps:
5 Together with your Assistant…Wearing Gloves
…..Carefully, Slowly raise and lift until the Vertical/
Center Column until it is standing freely on its
wheels.
6 Locate the M8 Hex Wrench. Remove the two
M8 x 20 bolts from the Vertical carriages. [See DI-
AGRAM: B] Locate the Horizontal Arm/Bar Car-
riage Assembly See [component identification]
page. Together with your assistant. Have your
assistant hold the Horizontal Arm/Bar Carriage
Assembly in place while you fasten it with the two
M8 x 20 bolts. Note the order [See DIAGRAM: B]
[Bolt, Spring washer and then Flat washer]. Hand
tightening with the Hex Wrench is recommended.
If you have a torque wrench tighten the M8 bolts
to 45Nm or 33 lb/ft not more.
7 Locate the M6 Hex Wrench. Locate the loose
Vertical / Brake Knob. Locate the location of Verti-
cal Carriage / Brake Knob See [Transportation
Set Screw] [See DIAGRAM: D & B]. With the M6
Hex Wrench Remove the transportation set screw
and replace with Vertical Carriage / Brake Knob.
Turn the Vertical Carriage /Brake Knob fully Clock
Wise to secure the vertical carriage in the upper
most or “parking position” [See DIAGRAM: D & B]
Summary of Contents for STA 01-360
Page 4: ...STA 01 360 series 4 Component Identification STA 01 360...
Page 5: ...STA 01 360 series 5 Component Identification STA 01 360...
Page 13: ...STA 01 360 series 13 Assembly Diagrams...
Page 14: ...STA 01 360 series 14 Assembly Diagrams...
