Studio Titan STA 01-350MK2, Manual, Page: 14 / 18

STA 01-350MK2 series 14
Assembly Steps:
8. Locate two M8 Hex wrenches. Locate the Bas-
ket. Locate the Basket Shaft. [See Component
Identification STA 01-350MK2 Diagram] Refer to
section “Cross Threading Components.” With the
first M8 hex key hold the M8 screw at the top of
the Basket shaft. With the second M8 hex key
loosen the M8 screw at the bottom of the Basket
shaft. Attach the Basket to the Basket Shaft.
Note the order of fastener connection: [Screw ,
Flat washer, Basket Plate, Flat Washer]. [See: DI-
AGRAM: C]
9. CAUTION: [Only with the Horizontal Arm/Bar in
the upper most positon “parking position”.] Slowly
release the Vertical Carriage Knob/brake by turn-
ing it Counter Clock Wise. This will release the
vertical carriage allowing it to travel freely up and
down the Vertical Center / Colum. Confirm that
the Vertical Carriage is free to move in both direc-
tions while using both hands to hold the Horizon-
tal Arm/Bar. Turn the Vertical Carriage Knob/brake
fully Clock Wise to secure the vertical carriage.
10. Locate the Two Horizontal Carriage Knob/
Brakes. [See Component Identification STA 01-
350MK2 Diagram] Turn the Horizontal Carriage
Knob/Brake Counter Clockwise to release and
confirm that the Horizontal Arm / Bar is free to
move left and right.
STOP SET-UP— Read below— GO TO STEP 11 If
anything seems unusual or if the vertical carriage
is not moving freely up or down. Stop Set-up and
send a few images of the stand to: in-
fo@studiotitanamerica.com for assistance.
Diagram: C