MULTISYSTEM End Feeds & Connections:
http://www.lightingaustralia.com.au/products/lighting-track/multisystem-48v-track/multisystem-48v-end-feeds-
connection-joints-accessories
There are two types of end power feeds: the non-polarised version (without mechanical key; codes
9501/… Fig.6) and the polarised version (with mechanical key on the left, code 9501-KL/… Fig.7 or on
the right, code 9501-KR/… Fig.8). If polarised end power feeds are used, it is important to respect the
wiring inside the item and to be very careful when inserting the end power feed into the track. Once
inserted with the key properly orientated, the end power feed must lie perfectly flush with the track
without protruding, and the key must not interfere with the track (Fig.9)
Use 4 x 1.5mm² cables to wire the end power feed. Remove the end power feed cover by loosening
the three screws A1-A2-A3 (Fig. 10) to access the electrical contacts. Apply force to removable
section 1 or 2 and feed the power cable through the resulting hole. Subsequently, depending on the
hole used, make a hole to pass the cable through the end cap or track (Fig.11). Remove the cable
sheaths and strip the cables (Fig.12), then wire the contacts of the end power feed taking care to
respect the markings on it (+/-). After completing the operations, use the screw-mount cable clamp
located on the power end feed, put the cover back on and tighten the three screws A1-A2-A3.
Lastly, insert the power end feed into the track (Fig.13) and secure it by means of device B fitted on
it, by turning until it stops (using an appropriate screwdriver, Fig. 14). The electrical connection to the
mains can only be achieved using items 9501…
4
11/7/2019
End Power Feed
Summary of Contents for MULTISYSTEM Series
Page 10: ...10 11 7 2019...
Page 11: ...11 11 7 2019...
