4
After you connected the effect to the mains, The fixture starts running
Stand Alone operation
In the stand alone mode, the fixture can be use without controller
Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one
master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
Addressing
The control board allows you to assign the DMX starting address,
Note;it’s necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.
CONTROL BOARD
The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
MENU MAP
The device has two operation modes, It can be operated in Stand Alone or in DMX controlled
Mode
DMX
Auto 1 /Auto 2 Auto 3 /Auto 4
XY effect 1/ XY effect 2 / XY effect 3 /XY effect 4
Random effect /Sound
DMX address
Setting DMX address from 001-512
Channel mode
Select 14 or 18 DMX channel
X reverse
ON/OFF
Y reverse
ON/OFF
XY exchange
ON/OFF
XY encoder
ON/OFF
Screen mode
ON display no light after 30 seconds
OFF display light always on
Version
Software version/DMX channel/run time/Total use time
Reset
ON/OFF
DMX-protocol
15/19 DMX channel mode
channel
value
function
1
0-255
Pan movement
Pan movement
2
0-255
Pan Fine
Pan fine movement
3
0-255
Tilt movement
Tilt movement
4
Tilt Fine
