<Removing the respirator>
After removing the top strap over the back of your head, remove the bottom
strap hanging around your neck.
CAUTION
In order to prevent the secondary infection, special
care must be taken not to touch the surface of the res
-
pirator when taking off the respirator.
■
Proper fitting
In order to achieve the original performance of the respirator, the respirator must
have best fit. The user is required to be fit tested according to OSHA 29 CFR
1910.134 either qualitatively or quantitatively prior to use. Conduct a fit check
following this procedure every time you put on the respirator.
1. Wear the respirator in the same manner as you
actually conduct during work.
2. Cover the respirator with two hands and exhale.
If it is not possible to cover the respirator with
both hands, use a polyethylene sheet to cover
the surface of the respirator, holding it down
with both hands and exhale.
3. Check that no air leaks through respirator-to-face
seal when you exhale. If you feel air leakage,
adjust the position of respirator and/or tention of
straps until the air leakage stops.
WARNING
1.
Before using the respirator in an actual operation, be sure to con
-
duct the inspection whether the respirator is properly fitted or not.
2.
If it is not possible to ascertain that the respirator is properly fitted,
do not use the respirator in an actual operation. Make the neces-
sary adjustments so that the respirator firmly fits your face.
If it is still not possible to ascertain that the respirator
is attached properly after those adjustments, inspect
each and every portion of the respirator at a safe
place.
(Please refer to “Check before donning”.)
■
Storage Method
Store the respirator in a clean, cool, dark and dry place.
CAUTION
Do not pile up or bend the respirators to store ; it may
cause problems such as fissures, deformation, etc.
■
Disposal Method
Put the used respirator in an airtight bag to prevent the particulate matters from
scattering before disposal in accordance with the applicable laws and regula-
tions.
■
NIOSH Approval Label
1-26-1, Nishigahara, Kita-ku, Tokyo
114-0024, JAPAN
+81-3-6903-7525
THIS RESPIRATOR IS APPROVED ONLY IN THE FOLLOWING CONFIGURATION:
TC-
Protection
1
Respirator
Cautions and Limitations
2
DD11-N95-5
84A-
9401
N95
X
ABCJMNOP
1. Protection
N95-Particulate Filter(95% filter efficiency level)
effective against particulate aerosols free of oil;
time use restrictions may apply.
2.
Cautions and Limitations
A-
Not for use in atmospheres containing less than 19.5 % oxygen.
B-
Not for use in atmospheres immediately dangerous to life or health.
C-
Do not exceed maximum use concentrations established by regulatory
standards.
J-
Failure to properly use and maintain this product could result in injury or
death.
M-
All approved respirators shall be selected, fitted, used, and maintained in
accordance with MSHA, OSHA and other applicable regulations.
N-
Never substitute, modify, add, or omit parts. Use only exact replacement
parts in the configuration as specified by the manufacturer.
O-
RRefer to User’s Instructions, and/or maintenance manuals for information
on use and maintenance of these respirators.
P-
NIOSH does not evaluate respirators for use as surgical masks.
For more information regarding the handling method of the
product, please contact:
Head O
ffi
ce
1-26-1, Nishigahara, Kita-ku, Tokyo 114-0024, Japan
Tel : +81-3-6903-7525
