Stryker SV1, Operation Manual

Page: 28 / 1124

E En ng glliis sh h
E EN N
1-22 KK-7100 REV 02 www.stryker.com
Operation
Activating and resetting the CPR release
WARNING
Always make sure that all persons and equipment are away from the area below and around the backrest before you
activate the CPR release. The CPR release is for emergency use only.
If the backrest is raised and you need quick access to the patient, you can position the product to 0° by activating the
CPR release.
You can find the instant CPR release lever at the head end section on both the left and right sides of the backrest.
To activate the CPR release:
1. Grasp either lever (A) and squeeze ( Figure 1-11 on page 1-22 ).
2. Guide the backrest down to the flat position.
To reset the backrest motor after activating the CPR release, press the backrest down button on the control panels or the
CPR button on the nurse control panel.
A
Figure 1-11: CPR release
Removing or replacing the headboard
WARNING
Always properly orient the headboard when replacing the headboard to avoid entrapment.
You can remove the headboard for patient accessibility and cleaning.
To remove the headboard:
1. Hang the patient control pendant onto the head end siderail.
2. Grasp the handles and lift the headboard straight up and off the product ( Figure 1-13 on page 1-23 ).
To replace the headboard:
1. Align the curved headboard corners with the foot end of the bed ( Figure 1-12 on page 1-23 ).