Stryker SV1, Operation Manual

Page: 25 / 1124

E En ng glliis sh h
E EN N
www.stryker.com KK-7100 REV 02 1-19
Operation
Transporting the product
WARNING
• Always store the power cord before transporting the product.
• Always lock the siderails in the full up position with the sleep surface horizontal in the lowest position when
transporting a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always make sure that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage
to the frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to move the product laterally. This may cause the product to tip.
CAUTION
• Do not use the siderails as a push or pull device. Always move the product using the integrated handles in the
headboard and footboard.
• Always remove the patient lift pole before transporting the product.
• Do not use the IV pole as a push or pull device.
• Always make sure that the IV pole is at a low height during transport.
To transport the product:
1. Lock the siderail control panel and patient control pendant functions (see Nurse control pendant on page 1-28 ).
2. Unplug the power cord from the wall outlet.
3. See Storing the power cord on page 1-18 .
4. Store the control pendants.
5. Retract the linen tray (see Extending or retracting the linen tray (option) on page 1-31 ).
6. Lower the IV pole.
7. Turn in the oxygen bottle holder toward the product.
8. Raise and lock the siderails in the full up position (see Raising or lowering the siderails on page 1-25 ).
9. Release the brakes (see Applying or releasing the brakes on page 1-19 ).
10. Push the product from the headboard or footboard.
Applying or releasing the brakes
WARNING
• Do not move the product after you apply the brakes.
• Always apply the brakes when a patient is getting into or out of the product to avoid instability.
• Always apply the brakes when the patient is unattended.
CAUTION
• Always apply the brake to prevent unintended movement.
• Do not apply the brake pedal to stop a moving product.