Stryker Prime TC, Maintenance Manual

Page: 15 / 64

P Prro occe ed du urre e::
1. Apply the brake.
2. Using a 3/16” hex wrench, remove the four flat head cap screws (A) and adaptors (B) to remove the seat back (C) from
the chair frame. Discard the screws, adaptors, and seat back (Figure 4).
A
B
A
B
D
Torque item A
to 70 ± 10 in-lb
Torque item A
to 70 ± 10 in-lb
C
F Fiig gu urre e 4 4 –– S Se ea att b ba acckk rre ep plla acce em me en ntt
3. Using a 3/16” hex wrench, install the four supplied flat head cap screws (A) and adaptors (B) to secure the supplied seat
back (C) to the chair frame. Using a 3/8” drive torque wrench, torque the screws to 70 ± 10 in-lb.
4. Apply the supplied Stryker label (D) in the appropriate color.
5. Verify proper operation before you return the product to service.
C Ch ha arrtt h ho olld de err rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• 5/32” hex wrench
• 3/8” drive torque wrench (in-lb)
P Prro occe ed du urre e::
1. Apply the brake.
2. Remove the seat back (see Seat back removal (page 10)).
3. Using a 5/32” hex wrench, remove the two button head cap screws (A) that secure the bottom of the chart holder to the
chair frame (Figure 5). Save the screws. When reinstalling the screws, use a 3/8” drive torque wrench to torque the
screws to 25 ± 5 in-lb.
1460-009-002 Rev B.0 11 EN