www.stryker.com
6390-009-001 REV B
57
Return To Table of Contents
UNLOADING A POWER-PRO COT FROM A VEHICLE (MODEL 6500/6506 & 6510/6516 WITH THE
POWER-LOAD OPTION)
WARNING
Loading and/or unloading an occupied cot into a vehicle requires a minimum of two (2) trained operators.
1. Lift the vehicle bumper to the raised position (if equipped).
2. Press and hold the release lever at the foot end of the Power-LOAD system and pull to remove the cot from the
vehicle patient compartment as shown in Figure 46.
WARNING
As the cot is unlocked for removal from the vehicle patient compartment, the Power-LOAD lifting arms will slightly raise
the cot. If the lifting arms do not raise the cot, then the operators must be ready to accept the entire weight of the cot
and patient to avoid injury.
3. Grasp the cot frame at the foot end to pull the cot out of the vehicle patient compartment as shown in Figure 47.
Note:
The head end lock LED indicators turn solid green only when the cot is ready to unload.
4. Press and hold the extend (+) button on the cot control switch to extend the cot undercarriage to the set load
height with the cot wheels on the ground.
5. Release the extend (+) button after the cot is no longer supported by the lifting arms. The lifting arms will continue
moving until they have fully lowered.
Operation Guide
Figure 46
Figure 47
