E
EM
MC
C iin
nffo
orrm
ma
attiio
on
n
W
WA
AR
RN
NIIN
NG
G -- The use of accessories, transducers, and cables, other than those specified or provided by the manufacturer,
could result in increased electromagnetic emissions or decreased electromagnetic immunity and result in improper
operation.
N
No
otte
e
•
The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). If it is used in a residential environment (for which CISPR 11 class B is normally required) this equipment might
not offer adequate protection to radio-frequency communication services. The user might need to take mitigation
measures, such as relocating or re-orienting the equipment.
•
This equipment is suitable for use in hospitals except for near active HF surgical equipment and the RF shielded room of
an ME system for magnetic resonance imaging, where the intensity of EM disturbances is high.
G
Gu
uiid
da
an
ncce
e a
an
nd
d m
ma
an
nu
uffa
accttu
urre
err’’ss d
de
ecclla
arra
attiio
on
n -- e
elle
eccttrro
om
ma
ag
gn
ne
ettiicc e
em
miissssiio
on
nss
The 2874 IIsso
oT
To
ou
urr pump is intended for use in the electromagnetic environment specified below. The customer or the
user of the 2874 IIsso
oT
To
ou
urr pump should assure that it is used in such an environment.
E
Em
miissssiio
on
nss tte
esstt
C
Co
om
mp
plliia
an
ncce
e
E
Elle
eccttrro
om
ma
ag
gn
ne
ettiicc e
en
nvviirro
on
nm
me
en
ntt
RF Emissions
CISPR 11
Group 1
The 2874 IIsso
oT
To
ou
urr pump uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference
in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The 2874 IIsso
oT
To
ou
urr pump is suitable for use in all
establishments other than domestic and those
directly connected to the public low voltage power
supply network that supplies buildings used for
domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
W
WA
AR
RN
NIIN
NG
G
•
Portable RF communications equipment, including peripherals such as antenna cables and external antennas, should
be no closer than 12 inches (30 cm) to any part of IIsso
oT
To
ou
urr, including cables specified by the manufacturer.
•
Avoid stacking or placing equipment adjacent with other equipment to prevent improper operation of the products. If
such use is necessary, carefully observe stacked or adjacent equipment to make sure that they are operating properly.
R
Re
ecco
om
mm
me
en
nd
de
ed
d sse
ep
pa
arra
attiio
on
nss d
diisstta
an
ncce
ess b
be
ettw
we
ee
en
n p
po
orrtta
ab
blle
e a
an
nd
d m
mo
ob
biille
e R
RF
F cco
om
mm
mu
un
niicca
attiio
on
n e
eq
qu
uiip
pm
me
en
ntt a
an
nd
d tth
he
e 2
28
87
74
4
IIsso
oT
To
ou
urr p
pu
um
mp
p
The 2874 IIsso
oT
To
ou
urr pump is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. The customer or the user of the 2874 IIsso
oT
To
ou
urr pump can help prevent electromagnetic interferences by
maintaining a minimum distance between portable and mobile RF communications equipment (transmitters) and the
2874 IIsso
oT
To
ou
urr pump as recommended below, according to the maximum output power of the communications
equipment.
B
Ba
an
nd
d ((M
MH
Hzz))
S
Se
errvviicce
e
M
Ma
axxiim
mu
um
m P
Po
ow
we
err
((W
W))
M
Miin
niim
mu
um
m S
Se
ep
pa
arra
attiio
on
n D
Diisstta
an
ncce
e
((m
m))
2874-009-002 Rev A.1
35
EN
