A
Acccce
essss d
diia
ag
gn
no
ossttiicc m
mo
od
de
e
P
Prro
occe
ed
du
urre
e::
1. Make sure that the support surface hoses are plugged into the pump and there is no weight on the support surface.
2. Power on the pump.
3. As the software loads, within 5 seconds of pressing the on button (Figure 2), press and hold the upper left button (Figure
IsoTour
F
Fiig
gu
urre
e 2
2 –– S
So
offttw
wa
arre
e llo
oa
ad
diin
ng
g
V
vx.x.x.xxx
F
Fiig
gu
urre
e 3
3 –– S
Se
errvviicce
e ssccrre
ee
en
n a
an
nd
d vve
errssiio
on
n
4. Press the lower left button to start the diagnostics mode.
N
No
otte
e -- The software version is located on the service screen (Figure 3).
5. The diagnostic results should all pass with OK.
a. If diagnostic results do not pass, investigate failed area referenced in the diagnostic test results.
EN
16
2874-009-002 Rev A.1
