Set up Instructions:
1. Place the ISOFLEX mattress on the bed frame. Insure that the mattress properly fits the bed frame on which
it is being placed. Using an ISOFLEX mattress on a bed frame of a larger or smaller width than the stated
ISOFLEX width may result in the mattress sliding and patient injury.
2. Insure that the foot end symbol (
) is located at the foot end of the bed frame. ISOFLEX
mattresses are equipped with a dedicated sloped heel section and must be installed with this section at the
foot end of the bed frame.
3. Place the linens on the mattress leaving them as loose as possible to avoid creating a “hammocking” effect
and increasing interface pressures.
4. Place the patient on the mattress.
Cleaning Instructions:
1. Gaymar mattress surfaces are designed for long-lasting comfort and reliability. In order to maintain these
products, they should be cleaned regularly using soap and water and a hospital grade disinfectant. Gaymar
recommends these disinfecting agents: Ecolab
®
Airkem
®
A-33 Quaternary Solution, 3M
®
Phenolic Disinfectant
Cleaner Concentrate Solution Product #18, or a 10% Chlorinated Bleach Solution.
2. Alcohol is not recommended because it can discolor and degrade the cover.
3. Allow to completely dry. The solution contact time is what makes the disinfectant process effective.
4. Wipe down the mattress with a clean dry cloth to remove any excess disinfectant.
NOTE:
The cover must be dry prior to storage or application of linens. Failure to remove excess disinfectant
could eventually degrade the cover.
5. An antimicrobial agent has been used to help prevent bacteria and fungus from destroying the coating of the
cover. Should unsightly stains, discoloration, brittleness, stickiness, or unpleasant odors become noticeable, the
antimicrobial agent may have become ineffective and the product should be replaced.
Distributed by:
Stryker Medical
3800 East Centre Avenue
Portage, MI 49002 USA
Copyright:
©2010. Stryker Medical, Inc. All rights reserved.
Trademark Information:
Stryker is a registered trademarks of Stryker Medical.
ISOFLEX is a trademark of Gaymar Industries, Inc.
Ecolab and Airkem are registered trademarks of Ecolab Inc.
3M is a registered trademarks of 3M Corporation.
This product is made with Intelli-Gel
®
* polymeric columned material and
Gelastic™* polymeric columned material.
*EdiZONE, LLC of Alpine, UT.
Patent Information:
This product is covered by one or more of the following US patents:
7666341, 7076822, 7060213, 6843873, 6797765, 6767621, 6447865,
6413458, 6099951, 6026527, 5749111 and other US and/or foreign patents
and pending patent applications.
P/N 101392000 Rev A 6/10
