58
72-1048E MM FL23SE REV A
Tools required:
3/8” Drive Ratchet
•
1/2” Socket
•
Rubber Mallet
•
Procedure:
Completely raise the bed.
1.
Unplug the bed power cord from the wall outlet.
2.
Position the brake/steer pedal to neutral.
3.
Using the 1/2” socket, remove the two bolts (A) holding the fifth
4.
wheel support (optional) or the lever support
(F, Figure 4.4 B, (without fifth wheel option)
pg. 62
) on the side of the defective pedal and lay the support down.
Keep the molded spacer (B).
Remove the pedal from the activation lever shaft. Use a rubber mallet if necessary.
5.
Reverse the above steps to install the replacement pedal.
6.
Brake/STeer Pedal rePlaCeMenT
F
C
G
F
E
D
A
A
B
B
Service Information
figure 4.4 a
Summary of Contents for FL23SE
