Stryker 7600-000-050, Maintenance Manual

Page: 34 / 78

4. Turn the battery off using the nurse control.
5. Raise and lock the lower leg section in the highest position.
6. Using a small flat screwdriver, un-clip the actuator cable retainer (A) from the control box (Figure 13).
7. Remove and save the actuator cable retainer.
8. Using a small flat screwdriver, push in on the power cord lock and gently pull outward on the power cord.
9. Remove the power cord from the control box.
10. Unplug the control cables and the battery cable from the control box.
N No otte e -- Pay attention to the control cable connection locations for reinstallation.
11. Using a 10 mm combination wrench and a 10 mm socket, remove the bolt (B) that secures the control box to the litter
frame (Figure 13).
12. Remove and discard the control box.
13. Reverse steps to reinstall.
14. Verify proper operation of the product before returning it to service.
B
A
B
F Fiig gu urre e 1 13 3 –– C Co on nttrro oll b bo oxx
B Ba atttte erryy rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• Diagonal pliers
• #2 Phillips screwdriver
P Prro occe ed du urre e::
1. Apply the brakes.
2. Raise the product to the highest height position.
3. Power down the bed and unplug the power cord from the wall outlet.
4. Remove the cable routing cover that secures the gatch (legrest) actuator cable to the litter frame.
EN 30 SK-7600 REV 06