Stryker 7600-000-050, Maintenance Manual

Page: 32 / 78

7. Using a 13 mm socket, remove and save the bolt (C), washers (D, E), and nut (F) that secures the bottom of the lower
leg section locking mechanism to the litter frame (Figure 12).
8. Remove and discard the lower leg section locking mechanism (B) (Figure 12).
9. Reverse steps to reinstall.
10. Verify proper operation of the product before returning it to service.
F Fiig gu urre e 1 12 2 –– L Lo ow we err lle eg g sse eccttiio on n llo occkkiin ng g m me ecch ha an niissm m
P Pa attiie en ntt cco on nttrro oll p pe en nd da an ntt rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• Diagonal pliers
P Prro occe ed du urre e::
1. Apply the brakes.
2. Raise the product to the highest height position.
3. Power down the bed and unplug the power cord from the wall outlet.
4. Remove the three cable routing covers that secure the gatch (legrest) actuator cable to the litter frame.
5. Cut the cable tie that secures the pendant to the bottom of the litter frame.
6. Unplug the patient control pendant cable from the junction box.
7. Dispose of the patient control pendant.
8. Reverse steps to reinstall.
9. Verify proper operation of the product before returning it to service.
EN 28 SK-7600 REV 06