Struers Discotom-50, Instruction Manual

Page: 14 / 156

Discotom-50
Instruction Manual
Discotom-50 is provided with various light diodes indicating the
status of the machine. Beep signals will sound if a key is pressed
when the function cannot be activated.
Light Diode and Beep Signals
Status Explanation Comments
Green POWER indicator on The main power switch has been
turned on.
Green AUTO indicator on AUTO mode is active.
Beep signal
You pressed AUTO, START
s
,
FORWARDS
v
or BACKWARDS
V
while the motor was running.
You pressed START
s
while the
protection guard was open.
Turn cooling valve to cutting position.
You pressed START
s
for cutting
while cooling valve isn’t in cutting
position.
Red STOP
o
indicator on
The emergency stop has been
pressed. Release the emergency stop to shut off
the STOP
o
indicator.
Red STOP
o
indicator on
and beep signal
The emergency stop has been
pressed and you tried to press
another key.
In AUTO mode: the feed speed is
too high.
10
The machine automatically turns the feed
speed down. Yellow FEED SPEED
REDUCED indicator on
An AUTO cut has finished. Feed
speed reduced. Reduce feed speed or press any key.
Yellow FEED SPEED
REDUCED and
Red STOP
o
indicator lights
come on
Cutting motor overloaded due to
heavy use:
Material is too hard
Feed speed setting too high
Rotational speed setting too high
Cutting table is jammed
Press any key to stop the indicators.
Solve the problem causing the machine
to stop, for example, by reducing the feed
speed, or using a different cut-off wheel,
then release the emergency stop.
Red STOP
o
indicator and
LOAD BAR in red area
Process halted.
Main motor or frequency inverter
overloaded or overheated.
Red STOP
o
indicator and
LOAD BAR in red area and
beep signal
START was pressed before re-
setting the warning indicator.
Press the STOP key
o
to re-set the
warning indicator and wait until the motor
or frequency inverter had cooled down.