Page 8 of 16
Operating Instructions
⚠
WARNING
To avoid serious bodily injury or death, and/or property damage, do not exceed the rated load
capacity.
When not in use, do not allow heavy loads to remain on the fork for an extended period of time.
Always lower the fork completely when not in use.
Note:
Numbers in parentheses refer to part numbers in the breakdown.
This pallet jack is designed for use with open style pallets or skids only. Closed style pallets must be
placed on top of the fork prior to use.
1.
Insert the fork into the pallet.
2.
To raise the fork, push the control lever all the way down, and pump the handle until the desired
fork height is reached.
3.
To move the handle without affecting the fork setting, set the control lever in the center neutral
position. The load can now be pushed or pulled using the handle.
4.
To lower the fork, pull the lever all the way up. Allow the load to descend slowly in a controlled
manner. The lever is spring-loaded and will return to the neutral position when released.
Adjusting the Control Handle
– 3 Positions
On the Handle Tube (1) of this pallet jack, you can find the Control Lever (5), which can be placed in
three positions (Fig. 3):
LOWER
Pull the Control Lever (5) up and the forks / load will lower to the desired height. The
Control Lever (5) will move back the neutral position when released.
NEUTRAL
When the Control Lever (5) is in the middle position, the forks will not move when the
Handle Tube (1) is pumped. The Control Lever (5) must be in the neutral position when
the pallet jack is driven.
LIFT
Push the Control Lever (5) down and pump the Handle Tube (1) to raise the forks / load
to the desired height.
Fig. 3
Lower
Neutral
Lift
