Page 6 of 12
Specific Operation Warnings
⚠
WARNING
Do not exceed loading capacity.
Only use on a hard level surface.
Ensure the load is secure by load constraining straps before moving.
Do not use the if the height of the furniture exceeds 32 inches or if the units are less than 20
inches apart or more than 157 inches apart.
Check both units for damage before operating the furniture mover. If there are visible defects, do
not use the machine. Have any damaged parts replaced by a qualified service provider.
Do not leave furniture unattended while raised up on the unit. Always lower the furniture on to the
floor before leaving unattended.
Never raise the furniture more than once inch off the floor.
Always plan your route before moving furniture.
Avoid any sudden movements.
Never use the furniture mover for towing furniture behind a moving vehicle.
Never operate the furniture mover alone. Two people are required to properly operate the unit.
Assembly Instructions
Remove the fork pin at the free end of the track rod, set the steering handles parallel to each other,
and push the fork of the track rod over the arm of the steering handle. Then replace the previously
removed fork pin through the fork and arm and secure it with a split ring.
The second unit is assembled in the same way.
Operating Instructions
Before using, the transport components should be checked for function, and for any damage. If there
are visible defects, the components should not be used. Damaged parts must be replaced.
Since the hydraulic furniture mover consists of two parts, it is necessary for two people to operate it.
Before transporting cabinets, the platforms should be lowered to the floor until the transport units are
standing vertically.
Push the platform of the units under the side faces (narrow faces) of the cabinet until the top and
bottom of the transport platform frame are resting against it. The centers of the platform must be
beneath the center of gravity of the cabinet.
Place the securing straps in position and tighten them. The straps will connect both units and, when
used correctly, prevent them from slipping out of position. Here, the strap ends must be under direct
tension. The straps must not be pulling around the edge of a cabinet, etc. If necessary, an additional
strap surrounding it should be used. This must be fed through the strap loops on the units. However,
the maximum overhang must not be more than 7 7/8
”.
*Always follow manufacturer instructions*
*AAA Rent-All 225-291-1356*
