Page of 8
4
3. Insert the Rear Axle through the Rear Axle Frame as shown (Fig.3). Using the small
6*15 mm bolts, washers and nuts attach the tray (front first) to the frame using the Small
Reinforcing Plate . Place the plate under the front rim of the tray lining up the holes with
the predrilled holes in the (pre-welded) Front Tray Bracket. Hold each nut with a wrench
or pliers while tightening each bolt with a flat head (slotted) screwdriver.
4. Slide one Axle Sleeve onto each end of the Rear Axle (Fig.4). Using the washers packaged
with the Cotter Pins, followed by a Wheel (with valve stem facing towards you) onto each
end of the Rear Axle. Slide a Cotter Pin through the predrilled hole at the end of the Axle.
Open the Cotter Pin and wrap the ends of the Pin back around the Axle to secure the wheel.
(Note: Axle Sleeves are not used on the Front Axle)
Fig.2
Fig.3