StrongLink SL032 V3.0
http://www.stronglink-rfid.com
13
4-4-18. Power Down
0xBA
Len
0x50
Checksum
Response:
0xBD
Len
0x50
Status
Checksum
Status: 0x00:
Operation succeed
0xF0:
Checksum error
4-4-19. Write Perso
0xBA
Len
0x80
Bnr
Data
Checksum
Bnr:
2Byte Block or Key Address to be written, MSB first.
For example,
Master Key Address is 0x9000, and write it as 0xFFFF..FF(16Bytes)
BA14809000FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFBEh
Configuration Key Address is 0x9001, and write it as 0xFFFF..FF(16Bytes)
BA14809001FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFBFh
Switch to Level 2 Key Address is 0x9002, and write it as 0xFFFF..FF(16Bytes)
BA14809002FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFBCh
Switch to Level 3 Key Address is 0x9003, and write it as 0xFFFF..FF(16Bytes)
BA14809003FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFBDh
Data:
Value of the key or data
Response:
0xBD
Len
0x80
Status
Checksum
Status: 0x00:
Operation succeed
0x11:
Communicate with card failed
0x12: Card Write Perso failed
0xF0:
Checksum error
4-4-20. Commit Perso
0xBA
Len
0x81
Checksum
This command commit the Write Perso and switch the card to security level 1(SL1 card) or
level 3(SL3 card).
Response:
0xBD
Len
0x81
Status Checksum
Status: 0x00:
Operation succeed
0x11:
Communicate with card failed
0x13: Card Commit Perso failed
0xF0:
Checksum error
Attention: According to NXP MifarePlus card document, Commit Perso will make effect
after you have “Write Perso” the Master KEY, Configuration KEY and SWL3 KEY.
If your card is L1 card, after Commit Perso, the card will switch L0 to L1;
If your card is L3 card, after Commit Perso, the card will switch L0 to L3.
4-4-21. Get firmware version
0xBA
Len
0xF0
Checksum
Response: