www.strongarminc.com
ASSEMBLY
Use the parts drawing as your guide to assembly. Lay all parts and assemblies out in front of you before
beginning. We recommend 2 people and the following procedure:
1) Attach rear Caster Wheels (#6) to rear of Base (F)
2) Insert Leg (G) into Base (F) and lock into position using bolt (#12)
From this point, it is recommended that you leave a “loose fit until you have all of the components assembled
and then tighten each piece once finished.
3) Attach Support Post (C) to Base (F).
4) Attach Support Brackets (D) to Support Post (C) and Base (F)
5) Attach Boom (B) to Support Post (C)
6) Attach bottom of Hydraulic Ram (E) to Support Post (C)
7) Attach top of Hydraulic Ram (E) to Boom (B)
At this time go around all of the components and ensure that all nuts and bolts are tight.
8) Insert Boom Extension (A) into Boom (B) and secure.
9) Attach Positioning Handle (#22) to Support Post (C)
10) Attach Swivel Hook (#18) to Boom Extension (A)
OPERATING
Lifting
1) Adjust the boom position to the appropriate position for the load being lifted and secure with the nut and
bolt provided.
2) Ensure the legs are extended and fixed according to the boom position in such a way as to provide the
maximum stability of the jack and load being lifted.
3) Using the end of the jack handle, turn the release valve clockwise until tight (do not overtighten).
4) Insert the jack handle into the pump receiver and operate the pump until the desired height is attained.
Lowering
1) Using the end of the jack handle,
SLOWLY
turn the release valve counterclockwise until the load begins
to lower.
2) There is never any reason to turn the release valve more than 2 full turns counterclockwise
