TM
PROFESSIONAL LIFTING
& SERVICE EQUIPMENT
MAINTENANCE
Use a good grade of hydraulic jack oil. Never mix different types of fluid. DO NOT USE transmission fluid, motor oil,
turbine oil, glycerin or similar products. Use of other than a good quality Hydraulic Jack Oil will likely result in load
bearing seal failure which will cause sudden and unexpected loss of pressure to ram.
IMPORTANT: READ THESE INSTRUCTIONS AND ALL WARNINGS PRIOR TO USING THIS EQUIPMENT.
UNDERSTAND ALL OPERATING PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
FAILURE TO DO SO COULD CAUSE AN ACCIDENT RESULTING IN SERIOUS OR FATAL INJURY AND/OR
PERSONAL PROPERTY DAMAGE.
OPERATING INSTRUCTIONS - 135 35 Ton Shop Press
WARNING
The use of shop equipment is subject to certain hazards that cannot be prevented by mechanical means, but only by exercise of
intelligence, care, and common sense. It is therefore essential to have personnel involved in the use and operation of equipment
who are careful, competent, trained, and qualified in the safe operation of this equipment and its proper use. Examples of hazards
are dropping, tipping, or slipping of parts/components caused primarily by improperly securing loads, overloading, off-centered
loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
The owner and / or operator shall study and understand the product and safety instructions before operating this equipment. Safety
information shall be emphasized and understood. If the operator is not fluent in English, the product and safety instructions shall be
read to and discussed with the operator in the operator’s native language by the purchaser / owner or his designee, making sure
that the operator comprehends their contents.
A copy of these instructions / warnings shall be retained for future reference.
INSPECTION
Visual inspection shall be made before each use of this equipment, checking for abnormal conditions, such as cracked welds, leaks,
damaged, loose or missing parts. This equipment shall be removed immediately from service if it is believed to have been
subjected to an abnormal or shock load, the equipment shall be inspected by a qualified repair facility. Owners and / or operators
should be aware that repair of this equipment may require specialized knowledge and facilities. It is recommended that this
equipment be inspected annually by a qualified repair facility. Defective parts, decals, safety labels or signs should be replaced with
Strongarm specified parts.
WARNING
When using various shop equipment, basic safety precautions should always be followed.
Keep work area clean and free from debris.
Keep children away from work area and shop equipment. Keep hands and feet from loading area.
Always wear protective eyewear during press operation. If possible position press in an isolated area and
shield it to prevent possible injury to others.
Ensure press is stable and that the components to be pressed shall be well supported and aligned to prevent
slippage and breaking. Make sure press bed pins are inserted in the upright frame holes all the way and the
pins are fully supporting the press bed channel flanges before pressing.
Some parts being pressed may have a tendency to pop out of the press or explode under pressure. Parts
being pressed should be shielded against shattering under pressure.
The press is designed for pressing, bending and straightening purposes only.
Do not exceed the rated capacity of the press. Never apply excessive force to a work-piece and always use a
force gauge to accurately determine the applied load.
Check press for loose or damaged parts before each operation. Replace damaged parts and tighten all loose
bolts before operating.
Never leave loaded press unattended.
Ensure the user is familiar with the controls and operational characteristics of this product and aware of the
potential hazards associated with its use.
No alterations shall be made to this product.
Failure to heed these instructions may result in personal injury and/or property damage.
