Strong SRT 8201, User Manual

Page: 7 / 22

This manual provides complete instructions for installing and using this receiver. The following symbols
will serve as follow.
Warning
Indicates warning information.
Tips
Indicates any other additional important or helpful information.
MENU
Represents a button on the remote control or the receiver.
(bold Characters)
Move to
Represents a menu item within a window.
(Italic Characters)
1.4 accessories
1. User manual
2. 1xremote control unit
3. 2x batteries (AAA type)
WaRNING:
The batteries should not be recharged, disassembled, electrically short-circuited, be
mixed or used with other types of batteries. If rechargeable accumulators instead of
batteries are going to be used (e.g. NiMH), we recommend using types with low self-
discharge to ensure long time operation of your remote control.
1.5 Usage of external USb devices
„ „
It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible
to USB 2.0 specifications, recording, playback and other multimedia functions of the receiver
might not work properly.
„ „
To ensure best performance of your USB storage device please format it via your receiver
(through the menu “
Media ”) to FAT32 system. Other file systems are not supported by the
receiver. However, it is possible to use already NTFS formatted disks.
„ „
STRONG cannot guarantee compatibility with all types of USB storage devices.
„ „
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
specifications may exceed the supported output of your receiver (max.5 V/800 mA). If so,
please connect your USB HDD to an according external power adapter.
„ „
It is advised not to store important information on USB storage devices used with the
receiver. Always make backups of data on your USB storage device before using it with this
receiver. STRONG will not take responsibility for any loss of information or circumstances
caused by loss of information.
2.0 YOUR RECEIvER
2.1 DEfaUlT PIN: 1234
2.2 front Panel
Fig. 1
1.
4 digits display:
Indicates current time in STANDBY mode
Indicates current channel number in OPERATING mode
2.
IR sensor:
Point your remote control towards this sensor.
3.
Mode indicator:
RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode
4.
USb:
Connector for USB storage devices.
2.3 Rear Panel
Fig. 2
1.
aNT IN
To connect to your antenna for reception of broadcasted signals.
2.
aNT OUT
To connect the terrestrial antenna signal to your TV set. This
connection will allow you to watch digital terrestrial programmes
depending on the tuner of your TV and local broadcast conditions
3
English
PaRT 1 • English